Forum

Hello Sean,l2gen run successfully giving a 'senz' raster as output. The mistake was at the selection of the 'senz' parameter in Products tab.I only selected the 'senz' marked by the red arrow (see attached image). After also selecting the child 'senz' it worked.Thank ...

Sean,What is shown in the picture is what I expect as an output. Checking the log file, l2gen did not run for senz.I tried to explicitly provide the extra parameters through a .par file and l2gen fails again.I'm not experienced with seadas so at the moment I'm clueless as to what I'm doi...

Sean,

l2run run following your tip (specifying geometric parameters senz, ... ). Problem now is, where are the corresponding output rasters? In the output product rasters folder, there are only standard products like chl, pic, poc etc.
Thanks for your help.

Hi Sean,

thanks for the response. Do you mean that I should adjust (essentially, diselect) the 'wavelength limiters' when running l2gen? Because this also fails.

Regards,
Liten

Hi,I want to process a L1B 250m image and extract Zenith Angle of Observation (view zenith angle). While l2gen runs successfully when creating a 250m resolution LAC product, it fails when 'senz' is also chosen as an output product. What am I missing here?Running SEADAS 7.5 GUI on an Ubuntu 1...

gnwiii,

Thanks for replying. I did run the LUT update from the GUI and it worked indeed.
I installed seadas using the terminal so I didn't check the aqua box.
Thanks again for helping, might be coming back with more questions!

Liten

Hello,I'm new to seadas and I want to process Modis Chl and SST data products. After installing the OC processors according to https://seadas.gsfc.nasa.gov/downloads/ , I'd like to create a 3-day composite of sst products by: 1. using l2bin on L2 products acquired on the same day2. combine 3...