stand alone OCSSW

orek · by **orek** » Mon May 07, 2018 8:11 am America/New_York

I am wondering if it is possible to use OCSSW independent from the SEADAS. I do not want to use or install any GUI of new seadas which I find chaotic in comparison with our lovely old seadas:)... I need to use l2bin and l3mapgen.

Best

Hasan

OB.DAAC-EDL - SeanBailey · by **OB.DAAC-EDL - SeanBailey** » Mon May 07, 2018 9:07 am America/New_York

Yes. See https://seadas.gsfc.nasa.gov/downloads/ - scroll down the page about halfway...

orek · by **orek** » Mon May 07, 2018 9:43 am America/New_York

I already did the installation. When I run the l2bin (/home/orek/ocssw/run/bin/linux_64/l2bin) I got an error message "/data3/swdev/V2015.4/build/src/l2bin/l2bin.c: Permission denied". And during the installation it writes both on /root and /home/ directory which I find bit strange. I was using it with seadas-beam before, now I prefer using it without seadas-beam because seadas-beam is not running efficiently on my server either ubuntu or CentOS.

by **OB SeaDAS - dshea** » Mon May 07, 2018 12:10 pm America/New_York

What command did you use to install?
Did you run the install_ocssw.py as root?

don

orek · by **orek** » Mon May 07, 2018 5:17 pm America/New_York

Hi Don,

I did the installation again and now everything is working. Regarding my first installation, I tried few times by a normal user but not succeed so I run the script with sudo and did the installation.
During the last installation, I have put --git-branch=<version> "7.4" which I have no idea what does this imply and could not find any documentation about it (All I have found are irrelevant. Git version on my server is xx.xxx.xx.xx.

Hasan

by **OB SeaDAS - dshea** » Tue May 08, 2018 11:32 am America/New_York

you need to give install_ocssw.py the version of SeaDAS. it should be:

--git_branch=v7.4

If you run the installer from the GUI, it takes care of all of this.

don