Current differencing buffered amplifier: Difference between revisions

Revision as of 20:58, 28 March 2014

Latest revision as of 19:45, 23 July 2023

(2 intermediate revisions by 2 users not shown)

Line 1:

{{Orphan|date=February 2009}}

[[Image:CDBA block.gif|thumb|270px|Block diagram of the CDBA]]

Line 12 ⟶ 11:

#<math>Vw=Vz</math>.

Here, the current through the z-terminal follows the difference ofbetween the currents through p-terminal and n-terminal. Input terminals p and n are internally grounded. The difference of the input currents areis converted into the output [[voltage]] Vw, therefore CDBA element can be considered as a special type of current feedback amplifier with differential current input and grounded y input.

The CDBA is simplifyingsimplifies the implementation, is free from parasitic capacitances, able to operate in the frequency range of more than hundreds of MHz (even GHz!), and suitable for current mode operation while, it also provides a voltage output.

Several voltage and current mode continuous-time filters, oscillators, analog multipliers, inductance simulators and a PID controller have been developed using this active element.

Line 20 ⟶ 19:

==References==

*Acar, C., and Ozoguz, S., “A new versatile building block: current differencing buffered amplifier suitable for analog signal processing filters”, Microelectronics Journal, vol. 30, pp.&nbsp;157–160, 1999.

*Ali Ümit Keskin, "A Four Quadrant Analog Multiplier employing single CDBA", Analog Integrated Circuits and Signal Processing, vol. 40, no. 1, pp.&nbsp;99–101, 2004.

*Tangsrirat, W., Klahan, K., Kaewdang, K., and Surakampontorn, W., “Low-Voltage Wide-Band NMOS-Based Current Differencing Buffered Amplifier” ECTI Transactions on Electrical Eng., Electronics, and Communications, vol. 2, no. 1, pp.&nbsp;15–22, 2004.