Closed-loop transfer function: Difference between revisions

Revision as of 16:09, 12 March 2019

Latest revision as of 16:38, 7 May 2024

(19 intermediate revisions by 11 users not shown)

Line 1:

{{short description|Function describing the effects of feedback on a control system}}

A '''closed-loop transfer function''' in [[control theory]] is a mathematical expression ([[algorithm]]) describing the net result of the effects of a closed ([[feedback]]) [[loop (telecommunication)|loop]] on the input [[signal (information theory)|signal]] to the circuits enclosed by the loop.

AIn [[control theory]], a '''closed-loop transfer function''' in [[control theory]] is a [[mathematical expression ([[algorithmfunction]]) describing the net result of the effects of a closed ([[feedback]]) [[loopcontrol (telecommunication)|loop]] on the input [[signal (information theory)|signal]] to the circuits[[plant enclosed(control bytheory)|plant]] theunder loopcontrol.

== Overview ==

The closed-loop [[transfer function]] is measured at the output. The output signal [[waveform]] can be calculated from the closed-loop transfer function and the input signal. Signals may be [[waveform|waveforms]], [[image|images]], or other types of [[data stream|data streams]].

An example of a closed-loop block diagram, from which a transfer function may be computed, is shown below:

[[Image:Closed Loop Block Deriv.png]]

The summing node and the ''G''(''s'') and ''H''(''s'') blocks can all be combined into one block, which would have the following transfer function:

: <math>\dfrac{Y(s)}{X(s)} = \dfrac{G(s)}{1 + G(s) H(s)}</math>

<math>G(s) </math> is called the [[Feed forward (control)|feed forward]] transfer function, <math>H(s) </math> is called the [[Feedback#Control theory|feedback]] transfer function, and their product <math>G(s)H(s) </math> is called the '''open-loop transfer function'''.

==Derivation==

We define an intermediate signal Z (also known as [[error signal]]) shown as follows:

[[Image:Closed Loop Block Deriv.png]]

Using this figure we write:

Line 19 ⟶ 23:

: <math>Y(s) = G(s)Z(s) </math>

: <math>Z(s) =X(s)-H(s)Y(s) </math>

Now, plug the second equation into the first to eliminate Z(s):

: <math>Y(s)+ = G(s)H[X(s)Y-H(s) = G(s)XY(s)]</math>

Move all the terms with Y(s) to the left hand side, and keep the term with X(s) on the right hand side:

: <math>Y(s) = +G(s)(X(s)-H(s)Y(s)) = G(s)X(s) - G(s)H(s)Y(s)</math>

Therefore,

: <math>Y(s)+G(s)H(s)Y(s) = G(s)X(s)</math>

: <math>Y(s)(1+G(s)H(s)) = G(s)X(s)</math>

: <math>\Rightarrow \dfrac{Y(s)}{X(s)} = \dfrac{G(s)}{1+G(s)H(s)}</math>

==See also==

*[[Federal Standard 1037C]]

*[[Open-loop controller]]

* {{section link|Control theory|Open-loop and closed-loop (feedback) control}}

== References ==