Automatic frequency control: Difference between revisions

Revision as of 01:16, 2 February 2025

Latest revision as of 01:52, 12 June 2025

(3 intermediate revisions by 2 users not shown)

Line 1:

{{Short description|Radio circuit}}

{{Unreferenced|date=December 2009}}

[[File:APCh2.svg|thumb|Basic automatic frequency control in a radio receiver. У = RF amplifier stages, Д = frequency discriminator stage]]

In [[radio]] equipment, '''Automatic Frequency Control''' ('''AFC'''), also called '''Automatic Fine Tuning''' ('''AFT'''), is a method or circuit to automatically keep a [[resonant circuit]] [[Tuner (electronics)|tuned]] to the frequency of an incoming [[radio signal]].<ref>Rider 1937, pp. 2-3.</ref> It is primarily used in [[radio receiver]]s to keep the receiver tuned to the frequency of the desired station.{{citation needed|date=June 2025}}

In [[radio communication]], AFC is needed because, after the [[bandpass]] frequency of a receiver is tuned to the frequency of a [[transmitter]], the two frequencies may drift apart, interrupting the reception. This can be caused by a poorly controlled transmitter frequency, but the most common cause is drift of the center bandpass frequency of the receiver, due to thermal or mechanical drift in the values of the electronic components.{{citation needed|date=June 2025}}

Assuming that a receiver is nearly tuned to the desired frequency, the AFC [[electrical network|circuit]] in the receiver develops an error voltage proportional to the degree to which the receiver is mistuned. This error voltage is then fed back to the tuning circuit in such a way that the tuning error is reduced.<ref>Rider 1937, p. 7.</ref> In most [[frequency modulation]] (FM) detectors, an error voltage of this type is easily available.{{citation needed|date=June 2025}} See [[Negative feedback]].

==Use==

{{Unreferenced section|date=DecemberJune 20092025}}

AFC was mainly used in radios and television sets around the mid-20th century. In the 1970s, receivers began to be designed using [[frequency synthesizer]] circuits, which synthesized the receiver's input frequency from a [[crystal oscillator]] using the vibrations of an ultra-stable [[crystal oscillator|quartz crystal]]. These maintained sufficiently stable frequencies that AFCs were no longer needed.

==See also==

* [[Frequency drift]]

* [[Phase-locked loop]] (PLL)

* [[Automatic gain control]] (AGC)

==ReferencesNotes==

{{reflist}}

==References==

*{{Cite book |last=Rider |first=John F. |url=http://www.tubebooks.org/Books/afcs.pdf |title=Automatic Frequency Control Systems |publisher=John F. Rider |year=1937 |___location=New York City}}

==External links==

*[http://www.radartutorial.eu/09.receivers/rx11.en.html Radar tutorialTutorial]

{{DEFAULTSORT:Automatic Frequency Control}}