Classless Inter-Domain Routing: Difference between revisions

Revision as of 08:29, 24 August 2025

Revision as of 10:31, 24 August 2025

Line 74:

==CIDR blocks==

CIDR is principally a bitwise, prefix-based standard for the representation of IP addresses and their routing properties. It facilitates routing by allowing blocks of addresses to be grouped into single routing table entries. These groups, commonly called CIDR blocks, share an initial sequence of bits in the binary representation of their IP addresses. IPv4 CIDR blocks are identified using a syntax similar to that of IPv4 addresses: a dotted-decimal address, followed by a slash, then a number from 0 to 32, i.e., {{IPaddr|a.b.c.d|n}}. The dotted -decimal portion is the IPv4 address. The number following the slash is the prefix length, the number of shared initial bits, counting from the most-significant bit of the address. When emphasizing only the size of a network, the address portion of the notation is usually omitted. Thus, a /20 block is a CIDR block with an unspecified 20-bit prefix.

An IP address is part of a CIDR block and is said to match the CIDR prefix if the initial ''n'' bits of the address and the CIDR prefix are the same. An IPv4 address is 32 bits so an ''n''-bit CIDR prefix leaves 32 − ''n'' bits unmatched, meaning that 2^32−''n'' IPv4 addresses match a given ''n''-bit CIDR prefix. Shorter CIDR prefixes match more addresses, while longer prefixes match fewer. In the case of overlaid CIDR blocks, an address can match multiple CIDR prefixes of different lengths.