Optical parametric oscillator: Difference between revisions

Revision as of 10:53, 17 August 2005

Revision as of 11:02, 17 August 2005

Line 2:

[[Category:Nonlinear optics]]

A '''continuous-wave optical parametric oscillator''' (cw-OPO) converts a [[Continuous_wave | continuous-wave]] input [[Laser | laser]] wave (called "pump") into two [[Continuous_wave | continuous-wave]] output waves of lower frequency (<math>\omega_s, \omega_i</math>) by means of [[nonlinear optics | nonlinear-optical interaction]]. The sum of the output waves frequencies is equal to the input wave frequency: <math>\omega_s + \omega_i=\omega_p</math>. For historic reasons, the two output waves are called "signal" and "idler". A special case is the degenerate OPO, when the output frequency is one-half the pump frequency, <math>\omega_s=\omega_i\omega_p/2</math>.

The OPO consists essentially of an [[Optical_cavity|optical resonator]] and a nonlinear optical crystal. The optical resonator serves to resonate at least one of signal and idler waves. In the nonlinear optical crystal, the pump, signal and idler waves overlap. The interaction between these three waves leads to amplitude gain for signal and idler waves and a corresponding deamplification of the pump wave. The gain allows the resonating wave(s) (signal or idler or both) to oscillate in the resonator, compensating the loss that the resonating wave(s) experience(s) at each round-trip. This loss includes the loss due to outcoupling by one of the resonator mirrors, which provides the desired output wave. Since the (relative) loss is independent of the pump power, but the gain is dependent on pump power, at low pump power there is insufficient gain to support oscillation. Only when the pump power reaches a particular threshold level, oscillation occurs. Above threshold, the gain depends also on the amplitude of the resonated wave. Thus, in steady-state operation, the amplitude of the resonated wave is determined by the condition that this gain equals the (constant) loss. The circulating amplitude increases with increasing pump power, and so does the output power.

Line 14:

An important feature of the OPO is the coherence and the spectral width of the generated radiation.

TheWhen the pump power is significantly above threshold, the two output waves are, to a very good approximation, [[Coherent state|coherent states]] (laser-like waves). Close to or below oscillation threshold, the output waves can exhibit interesting quantum properties such as [[Squeezed coherent state|squeezed quantum noise]] and sub-shot-noise intensity correlations ("twin beams")) The linewidth of the resonated wave is very narrow (as low as several kHz). The nonresonated generated wave also exhibits narrow linewidth if a pump wave of narrow linewidth is employed.

The output waves can be tuned in frequency by changing the path length of the optical resonator or by tuning the pump frequency.