Optical parametric oscillator: Difference between revisions

Revision as of 08:00, 5 July 2008

Revision as of 16:07, 19 July 2008

Line 1:

[[Image:IR Optical Parametric Oscillator.JPG‎|thumb|300 px|right|Infrared optical parametric oscillator]]

An '''optical parametric oscillator''' (OPO) is a [[parametric oscillator]] which oscillates at optical frequencies. It converts an input [[laser]] wave (called "pump") into two output waves of lower frequency (<math>\omega_s, \omega_i</math>) by means of [[nonlinear optics | nonlinear optical interaction]]. The sum of the output waves frequencies is equal to the input wave frequency: <math>\omega_s + \omega_i=\omega_p</math>. For historic reasons, the two output waves are called "signal" and "idler". A special case is the degenerate OPO, when the output frequency is one-half the pump frequency, <math>\omega_s=\omega_i=\omega_p/2</math>.

== Overview ==

The OPO consists essentially of an [[Optical_cavityOptical cavity|optical resonator]] and a [[Nonlinear Opticsoptics|nonlinear optical]] crystal. The optical resonator serves to resonate at least one of signal and idler waves. In the nonlinear optical crystal, the pump, signal and idler waves overlap. The interaction between these three waves leads to amplitude gain for signal and idler waves (parametric amplification) and a corresponding deamplification of the pump wave. The gain allows the resonating wave(s) (signal or idler or both) to oscillate in the resonator, compensating the loss that the resonating wave(s) experience(s) at each round-trip. This loss includes the loss due to outcoupling by one of the resonator mirrors, which provides the desired output wave. Since the (relative) loss is independent of the pump power, but the gain is dependent on pump power, at low pump power there is insufficient gain to support oscillation. Only when the pump power reaches a particular threshold level, oscillation occurs. Above threshold, the gain depends also on the amplitude of the resonated wave. Thus, in steady-state operation, the amplitude of the resonated wave is determined by the condition that this gain equals the (constant) loss. The circulating amplitude increases with increasing pump power, and so does the output power.

The photon conversion efficiency, the number of output photons per unit time in the output signal or idler wave relative to number of pump photons incident per unit time into the OPO can be high, in the range of tens of percent. Typical threshold pump power is between tens of milliwatts to several watts, depending on losses of the resonator, the frequencies of the interacting light, the intensity in the nonlinear material, and its nonlinearity. Output powers of several watts can be achieved.

Line 33:

== References ==

{{reflist}}

<div class="references-small">

<references/>

</div>

== External links ==

'''Articles on OPOs'''

* [http://www.rp-photonics.com/optical_parametric_oscillators.html] ''Encyclopedia of Laser Physics and Technology''

[http://www.rp-photonics.com/optical_parametric_oscillators.html] ''Encyclopedia of Laser Physics and Technology''

'''Companies that Commercialise Optical Parametric Oscillators'''

* [http://www.radiantis.com Radiantis]

[http://www.radiantis.com Radiantis]

==See also==