Network interface controller: Difference between revisions

Revision as of 23:00, 20 November 2004

Revision as of 17:53, 2 December 2004

Line 1:

[[Image:Network_card.jpg|right|thumb|300px|A typicaltransitional network card with both BNC "[[Thinnet]]" (left) and Twisted pair (right) connectors.]]

A '''network card''' (also called '''network adapter''', '''network interface card''', etc.) is a piece of [[computer hardware]] designed to provide for [[computer communication]] over a [[computer network]].

Line 5:

The card implements the electronic circuitry required to communicate using a specific [[physical layer]] and [[data link layer]] standard such as such as [[ethernet]] or [[token ring]]. This provides a base for a full network [[protocol stack]], allowing communication among small groups of computers on the same [[LAN]] and large-scale network communications through routable protocols, such as [[Internet Protocol|IP]].

A network card typically has a [[twisted pair]] or, [[BNC connector|BNC]], or [[Attachment Unit Interface|AUI]] socket where the network cable is connected, and a few [[Light-emitting diode|LED]]s to inform the user of whether the network is active, and whether or not there is data being transmitted on it.

Most newer computers have an [[ethernet]] interface built into the [[motherboard]], so a separate network card is not required unless multiple interfaces are needed or some other type of network is used.

Line 19:

*[[Host Bus Adapter]] (HBA)

[[Category:Computer hardware]]

[[de:Netzwerkkarte]]

[[es:Tarjeta de red]]